Victory Reach-In Manuale di Servizio Scaricare il pdf (Pagina 87)

Section 8 Component Replacement Procedures

8-7

Reversing Door Swing and Adjusting Door Tension

Solid Door

NOTE: To adjust the door tension only, see

step 8 of this procedure, page 8-9.

1. Release door spring tension

A. Insert a small Phillips screwdriver (the

same diameter as the holes) into the

spring housing.

B. Remove the tension pin and unload the

spring by backing off on the Phillips

screwdriver.

Important

Do not release or remove the screwdriver

after removing the tension pin.

NOTE: The tension pin on some early

production models was pushed in, rather than

screwed in. You can just pull it out.

C. Move the tension pin in the hinge one

space at a time to release the spring

tension.

NOTE: Be careful not to damage the threads

in the tension pin adjustment holes.

Figure 8-7: Release Door Spring Tension

2. Remove the door.

Important

Release door spring tension before removing

the door.

A. Remove the pivot pin from the bottom

hinge assembly.

B. Slide the door off the bottom hinge

and remove it.

3. Remove the hinge brackets from the

cabinet. Install the screws without the

brackets.

NOTE: Use short screws in the blank holes,

and long screws to fasten the hinge.

Figure 8-8: Spring Hinges

Continued on next page...

SV1156

SV1227

SPRING HINGE

TURN TOWARD HANDLES TO ADJUST

SPRING HINGE

TURN TOWARD HANDLES TO ADJUST

HANDLES

1 2 ... 82 83 84 85 86 87 88 89 90 91 92

Commenti su questo manuale

Nessun commento