Victory Reach-In Manuale di Servizio Scaricare il pdf (Pagina 91)

Section 8 Component Replacement Procedures

8-11

TENSION ADJUSTMENT

Use hand tools only for this procedure.

1. Completely release the door tension by

turning the door tension adjustment screw

clockwise.

2. Open the door approximately 2-3 inches.

3. Without touching the door, slowly turn the

door tension adjustment screw clockwise

until the door closes.

4. Turn the screw two more complete

revolutions.

NOTE: This is the factory tension setting. If

desired, you may slightly increase or decrease

the tension setting.

DOOR SAG ADJUSTMENT

Use hand tools only for this procedure.

Important

The reach-in cabinet must be level before

beginning the adjustment.

Figure 8-14: Door Sag Adjustment

Turn the door sag adjustment screw clockwise

to increase or counterclockwise to decrease

dimension B to visually match dimension A.

NOTE: Dimension A is not adjustable.

DOOR REMOVAL

WARNING

To prevent personal injury and/or cabinet

damage, perform this procedure with two

people, each capable of lifting 75 lb. (34 kg).

1. Release the door tension by turning the

door tension adjustment screw counter-

clockwise.

2. Use needle nose pliers to remove the

safety snap ring from the top pin shaft.

3. Use a standard screwdriver to carefully

pry the outer shaft retainer from the

torquemaster.

4. Lift the door up and out of the

torquemaster. Do not lower the door yet.

5. Align the hold-open arm stud on the door

with the key hole on the hold-open arm.

Disengage the door from the hold-open

arm.

6. Lower the door to disengage it from the

top hinge bracket pin.

SV1502

DISTANCE

“B”

DISTANCE “A”

SAFETY

SNAP RING

1 2 ... 86 87 88 89 90 91 92

Commenti su questo manuale

Nessun commento